How to Operate the KLOUD

Manual Adjustment Sequence 

You can find the video here: Change KLOUD Intensity. Instruction begins at the 54 sec mark.

1. Start a Program: You can only regulate the intensity while a program is currently running.

2. Access Intensity Mode: Press and hold the Start-Stop button. After approximately two seconds, the LEDs for P1 through P5 will light up to display the current intensity level.

3. Select Level: While continuing to hold the Start-Stop button, use the Program Selection button to cycle through the intensity levels.

4. Confirm: Once you release the Start-Stop button, the display returns to the standard mode, and your chosen program continues at the new intensity.

Intensity Levels

The intensity is indicated by the LEDs on the control unit:

• High: P1 through P5 are lit.

• Medium (Standard): P1 through P3 are lit.

• Minimal: Only P1 is lit.

Important Notes

• Persistence: The selected intensity remains saved for all future programs, even after the device is turned off, until you manually change it again.

• App Control: These adjustments can also be managed through the CENTROPIX app for greater convenience.

• Physical Folding: The physical intensity (measured in microtesla) can also be increased by correctly folding the applicators. For example, a triple-folded KLOUD mini can reach between 180 and 200 microtesla. However, if the device is not folded correctly, the intensity may be neutralized or reduced.